Welcome To The Official Website Of Shandong Aohuang Bearing Technology Co., Ltd
Email:ll@ahfbearing.com
2024-02-28
Mounted ball bearing unit combines rolling bearing with bearing seat. Most of the outer spherical bearings are made of spherical outer diameter and installed together with the imported bearing seat with spherical inner hole. They have various structural forms and good universality and interchangeability.
2024-02-28
AHF Bearings will supply： Customization: Bearing factories can tailor bearings to specific needs. Quality Control: Strict standards ensure reliable and durable products. Expertise: Skilled engineers provide technical support. Cost Efficiency: Direct sourcing may offer competitive pricing.
Classification of linear bearings
2022-12-22
(1) Standard type, clearance adjusted linear bearing, open linear bearing, extended linear bearing, general linear bearing (2) Flange type linear bearings can be divided into: round flange type, flange type, elliptical flange type, guide circle flange type, guide method flange type, guide ellipse flange type, and extended circle flange type.
2022-12-22
Needle roller bearings are equipped with thin and long rollers (roller length is 3~10 times the diameter, the diameter is generally not greater than 5mm), so the radial structure is compact, its inner diameter size and load capacity and other types of bearings at the same time,
Introduction to rod end spherical plain bearing
2022-12-22
Rod end spherical plain bearing vibration is very sensitive to the damage of rod end spherical plain bearing. For example, peeling, indentation, rust, crack, wear, etc. will be reflected in the rod end spherical plain bearing vibration measurement. Therefore, the vibration can be measured by using a special rod end spherical plain bearing vibration measuring device (frequency analyzer, etc.), and the specific abnormal conditions cannot be inferred from the frequency. The measured values are different due to the use conditions of the rod end spherical plain bearing or the installation position of the sensor. Therefore, it is necessary to analyze and compare the measured values of each machine before determining the judgment standard.
Selection of roller bearing types
2022-12-22
When selecting bearings, the main considerations are as follows: Load of bearing The size, direction and nature of the load on the bearing are the main factors for selecting the bearing. When selecting bearings according to the size of the load, compared with the point contact of ball bearings, the main components in roller bearings are in line contact, which is easy to bear the load, and the deformation after bearing is small.
2022-12-22
The purpose of ball bearing is to determine the relative position of two parts (usually shaft and bearing seat), ensure their free rotation, and transfer the load between them. At high speeds, such as in gyro ball bearings, this use can be extended to include free rotation with little wear in the bearings.
WhatsApp:
Email:
Office Address
Room 2611, Unit 2, Building 7, Dinghao Plaza, Gongye South Road, Gaoxin District, Jinan City, Shandong Province
